Materials:
* New axle seals (2 pcs.)
* Engine oil for automatic transmission
* Automatic transmission pan gasket
* Sealant for automatic transmission pan
* Set of sockets and wrenches
* Rags
* Oil drain container
Execution order:
1. Draining the automatic transmission oil
* Place the car on a flat surface.
* Locate the drain plug on the automatic transmission pan.
* Place a container under the stopper.
* Carefully unscrew the plug and drain the oil.
* Screw on the drain plug with a new gasket.
2. Removing the axle shafts
* Jack up and support the front of the vehicle.
* Remove the wheel from the desired side.
* Unscrew the stabilizer bar mounting bolts.
* Remove the bolts securing the upper suspension arm to the body.
* Lift the lower arm and remove the drive shaft from the spline in the gearbox.
3. Replacing oil seals
* Clean the oil seal seat on the axle shaft.
* Apply a thin layer of sealant to the seat.
* Install a new oil seal.
* Reassemble the drive in reverse order.
4. Repeat steps 2-3 for the other axle shaft.
5. Installing the automatic transmission pan
* Clean the pan flange and the surrounding surface of the gearbox.
* Apply a thin layer of sealant to the pan flange.
* Install the pan and tighten the mounting bolts.
6. Filling automatic transmission oil
* Fill in new automatic transmission oil through the filler hole on the gearbox.
* The volume of liquid to be filled depends on the car model, usually about 5-6 liters.
*Check the oil level according to the operating instructions.
Additional recommendations:
* It is recommended to replace drive seals in pairs, even if only one is replaced.
* Use high-quality oil seals and automatic transmission oil.
* Replacing oil seals requires certain knowledge and skills, so it is recommended to seek help from qualified specialists.