Required tools and materials:
* New automatic transmission selector
* Set of wrenches or ratchets
* Flat head screwdriver
*WD-40 or similar lubricant
Instructions for replacing the Toyota Corolla 110 automatic transmission selector:
1. Disconnect the negative terminal of the battery. This will prevent accidental short circuiting.
2. Move the automatic transmission selector to neutral position.
3. Remove the selector housing. It is usually secured with screws or snaps.
4. Disconnect the electrical connector from the old selector. Carefully pull out the connector without damaging it.
5. Unscrew the nuts or bolts securing the old selector. The location of fasteners may vary depending on the vehicle model.
6. Remove the old selector. Gently pull the selector up to remove it from the shift shaft.
7. Install a new selector. Align the new selector with the shift shaft and gently press it into place.
8. Tighten the mounting nuts or bolts. Don’t over-tighten them.
9. Connect the electrical connector to the new selector. Make sure the connector is securely seated.
10. Install the selector housing. Reassemble everything in reverse order.
11. Connect the negative terminal of the battery.
12. Check the operation of the selector. Start the engine and move the selector through all positions to ensure it operates properly.
Adviсe:
*If you are unsure, consult a qualified mechanic.
* Lubricate the shift shaft with WD-40 or similar lubricant to facilitate removal and installation of the selector.
* Be careful not to damage the electrical connector or the selector itself.