Required tools and materials:
* New automatic transmission oil filter gasket (part number: 35168-32010)
* Measuring container
* New automatic transmission fluid (Type T-IV)
* Funnel
* Set of wrenches or sockets
* Clean rag
Instructions:
1. Place the vehicle on a level surface and apply the parking brake.
2. Place a container under the car to collect fluid from the automatic transmission.
3. Locate the automatic transmission oil filter; it is usually located at the bottom of the transmission.
4. Unscrew the bolts securing the filter cover and remove the cover. Fluid will begin to leak from the automatic transmission. Be careful and let it drain completely.
5. Remove the old filter gasket and drain plug gasket.
6. Clean the filter surface of old gasket and debris.
7. Apply a new gasket to the filter and install the filter in place.
8. Install a new gasket on the drain plug and screw the plug into place.
9. Install the filter cover and tighten the bolts.
10. Fill the automatic transmission with new fluid. Use a funnel to avoid spills.
11. Check the fluid level in the automatic transmission using a dipstick. The level should be between the “cold” and “hot” marks on the dipstick.
12. Start the engine and let it run for a few minutes in park mode. Check for leaks around the filter.
13. Wipe up any spilled liquid and lower the vehicle to the ground.
Adviсe:
* Replace the automatic transmission fluid in accordance with the manufacturer’s recommendations.
* Use clean tools and materials to prevent contaminants from entering the transmission.
* Be careful not to overtighten the bolts as this may damage the filter housing.