Materials:
* T10 LED lamps (5 pcs.)
* Phillips screwdriver
* Flathead screwdriver or plastic spatula
Instructions:
1. Disconnecting the battery terminal:
* Disconnect the battery terminal to prevent short circuit.
2. Removing the gear selector panel:
* Locate the shift panel around the selector lever.
*Use a flat head screwdriver or plastic putty knife to carefully pry the panel up on one side and remove it by releasing the latches.
3. Replacing selector lamps:
*The shifter panel has five holes for T10 LED bulbs.
* Unscrew the old lamps by turning them counterclockwise.
* Insert new LED bulbs, matching the polarity (minus to minus, plus to plus).
* Rotate the lamps clockwise to secure them.
4. Installation of the shifter panel:
* Align the shifter panel with the selector lever.
*Press the panel until it snaps into place.
5. Battery connection:
* Reconnect the battery terminal.
6. Check:
* Start the engine and move the selector lever through all positions to check if the backlight is working properly.
Adviсe:
*Use high quality LED bulbs to ensure bright, long-lasting illumination.
* If the lamps do not turn on, check the polarity and make sure they are inserted firmly.
* Observe safety precautions when working with electrical equipment.