Materials:
* LED strips (color optional)
* Heat shrink tube
* Cables and connectors
* Glue or mounting tapes
Tools:
* Phillips screwdriver
* Soldering iron
* Side cutters
* Protective gloves
Instructions:
1. Preparing the tape:
*Measure and cut the LED strip to your desired length.
* Solder the wires to the contact pads of the LED strip, observing the polarity.
* Protect connections with heat shrink tubing.
2. Removing the selector:
* Disconnect the negative terminal of the battery.
* Slide the shift lever cover up and remove it.
* Unscrew the screws holding the selector and carefully lift it up. Be careful with wires.
3. Tape installation:
* Place the LED strip inside the selector housing, making sure it does not interfere with operation.
* Secure the LED strip with glue or mounting tapes.
4. Power connection:
*Connect the LED strip wires to the power source. It is recommended to use a fuse on the power line.
*You can connect the strip to the cigarette lighter power wire or directly to the battery (set the switch to turn on/off).
5. Assembly:
* Reinstall the selector and tighten the screws.
* Install the shift lever cover.
* Connect the negative terminal of the battery.
6. Setting:
*Turn on the LED backlight and adjust the brightness or color as needed.
Adviсe:
* Use low power consumption LED strip to avoid overloading the electrical system.
* Make sure the LED strip is well secured and does not interfere with gear shifting.
*If you are unsure of your electrical skills, consult a qualified professional.