Materials:
* New automatic transmission filter
* Gasket for automatic transmission pan
* Automatic transmission fluid
* Wrench or wrench with 10 mm head
* Wrench or wrench with 14 mm head
* Flat head screwdriver
* Funnel
* Clean container for draining liquid
Instructions:
1. Preparation:
* Place the car on a flat surface.
* Allow the engine to cool for safety.
* Stop the engine and place the gear shift lever in park position.
2. Draining fluid from the automatic transmission:
* Locate the automatic transmission pan from underneath the vehicle.
* Place a container under the drain hole.
* Loosen the drain plug using a 14mm wrench and drain the liquid into a container.
* Allow the liquid to drain completely.
3. Removing the automatic transmission pan:
* Loosen the bolts securing the automatic transmission pan to the housing using a 10 mm wrench.
* Be careful not to drop the bolts.
* Carefully remove the tray from the body.
* Remove the pan gasket.
4. Replacing the automatic transmission filter:
* Find the old automatic transmission filter in the pan.
* Remove the old filter by pulling it up from the tray.
* Insert the new filter into the housing, aligning its latches with the grooves on the housing.
* Press the filter until it clicks into place.
5. Installing the automatic transmission pan:
* Apply a fresh gasket to the automatic transmission pan.
* Install the tray onto the body, aligning its bolt holes.
*Tighten the pan bolts using a 10mm wrench.
6. Filling automatic transmission fluid:
* Locate the automatic transmission filler hole on the body and remove the filler hole cap using a flathead screwdriver.
* Insert a funnel into the filler hole and begin pouring fresh automatic transmission fluid.
*Add fluid until it begins to flow out of the filler hole.
7. Checking the fluid level:
* Install the filler cap and start the engine.
* Let the engine idle for a few minutes, using the selector lever to change gears.
* Stop the engine and check the fluid level using the dipstick.
*Add fluid as necessary to bring the level to the specified level.
8. Purification of waste liquid:
* Dispose of used automatic transmission fluid in accordance with local environmental regulations.
9. Resetting the automatic transmission error code (if necessary):
* Start the engine and let it idle for a few minutes.
* Turn off the engine and wait 30 seconds.
* Start the engine again and let it idle for a few more minutes.
* The automatic transmission error code should reset automatically.