Materials and tools:
* Special wrench for brake band
* Gap gauges
* Wrench set
* Rags
*Work gloves
Steps to adjust the brake band of a Nissan automatic transmission:
1. Prepare the automatic transmission:
* Place the vehicle on a level surface and apply the parking brake.
* Remove the automatic transmission pan and drain the oil.
2. Find the brake band:
* Remove the valve plate to gain access to the brake band.
3. Measure the gap:
* Insert the feeler gauge between the brake band and the drum. The clearance should be as specified in the vehicle’s service manual.
4. Adjust the brake band:
*Use a special brake band wrench to adjust it.
* Tighten or loosen the adjustment bolts until the correct clearance is achieved.
5. Check the gap:
*Measure the gap again with a feeler gauge to ensure it is within specifications.
6. Reinstall the valve plate:
* Carefully reinstall the valve plate and tighten the bolts.
7. Install the automatic transmission pan:
* Install the automatic transmission pan and tighten the bolts.
8. Fill the automatic transmission with oil:
* Fill the automatic transmission with oil in accordance with the instructions in the vehicle service manual.
9. Check the oil level:
* Check the automatic transmission oil level using the dipstick and add if necessary.
10. Carry out a road test:
* Start the engine and let it idle.
* Drive the vehicle carefully to check that the brake band is operating properly.
Adviсe:
*Always follow the setup procedures outlined in your vehicle’s service manual for your specific model.
* Use only high-quality automatic transmission oil and filter.
*If you are unsure of your skills, seek assistance from a qualified mechanic.