Location of the automatic transmission selector sensor on the Hyundai Accent Tagaz
1. Open the hood.
2. Remove the air filter and its housing.
3. The automatic transmission selector sensor is located on the left side of the gearbox housing, immediately below the air filter.
Features of the automatic transmission selector sensor for Hyundai Accent Tagaz:
* Typically contains three wires: power, ground and signal.
* The wires are located in the connector that connects to the sensor.
* The sensor determines the position of the automatic transmission selector and transmits this information to the electronic control unit (ECU).
Replacing the automatic transmission selector sensor on a Hyundai Accent Tagaz:
Tools:
* Phillips screwdriver
* Wrench or ratchet
* New automatic transmission selector sensor
Instructions:
1. Disconnect the negative terminal of the battery.
2. Remove the connector from the automatic transmission selector sensor.
3. Unscrew the bolt or nut securing the sensor to the gearbox housing.
4. Remove the old sensor and install the new one.
5. Tighten the bolt or nut.
6. Connect the connector to the new sensor.
7. Connect the negative terminal of the battery.
8. Reset the ECU by disconnecting the battery for a few minutes.