Materials:
* Automatic transmission oil (about 6-8 liters)
* New automatic transmission filter
* New automatic transmission pan gasket
* New drain plug o-ring
* Tool set
Replacement procedure:
1. Preparation:
* Place the car on a flat surface.
* Apply the parking brake.
* Allow the engine to cool.
2. Draining old oil:
* Place a tray under the automatic transmission pan.
* Loosen the drain plug with a 17mm wrench.
* Drain the oil into the pan.
3. Replacing the automatic transmission filter:
* Unscrew the bolts securing the automatic transmission pan with a 10 mm wrench.
* Remove the pan.
* Remove the old automatic transmission filter.
* Reinstall the new filter.
4. Cleaning the tray and magnets:
* Clean the automatic transmission pan from old oil and dirt.
* Clean the magnets on the tray from metal shavings.
5. Pallet installation:
* Apply sealant to the pan gasket.
* Install the gasket on the pan.
* Secure the pan with bolts.
6. Filling with new oil:
* Pour new oil into the automatic transmission through the filler plug.
* Fill in oil until it begins to flow out of the inspection hole.
7. Checking the oil level:
* Start the engine and warm it up to operating temperature.
* Switch the automatic transmission selector lever to all positions with a delay in each position for 5-10 seconds.
* Move the selector lever to the Park (P) position.
* Check the oil level in the automatic transmission through the inspection hole. The oil should flow out in a thin stream.
*Add oil if necessary.
8. Tightening the control plug:
* Tighten the inspection plug with a 10 mm wrench.
9. Reset service counter:
*Connect the diagnostic scanner to the car.
* Enter the automatic transmission control unit.
* Reset the service counter.