Original part number:
* 43450-23001
Analogues:
*Corteco 20026390B
* Elring 379.460
* SKF VKJD 95001
* Victor Reinz 81-33186-00
* Quinton Hazell QHL340
Replacement Tips:
*Check the size and type of oil seal before purchasing, as there may be different options for different models and years of Hyundai Accent with automatic transmission.
* Make sure you have the necessary tools and experience to replace the seal.
*Follow the steps below for DIY replacement:
Required tools:
* Set of wrenches or screwdrivers
* Hammer
* Punch
* New oil seal
Replacement steps:
1. Disconnect the battery.
2. Raise the front of the car with a jack and install supports.
3. Remove the wheel on the right side.
4. Disconnect the steering rod from the rack.
5. Unscrew the hub nut and remove the hub and bearing.
6. Remove the drive shaft from the transmission.
7. Remove the old oil seal from the drive shaft by carefully prying it off with a screwdriver.
8. Apply grease to the seat of the new oil seal.
9. Install the new oil seal onto the drive shaft using a suitable drift or mandrel.
10. Reinstall the drive shaft into the transmission.
11. Install the hub and tighten the hub nut.
12. Connect the tie rod to the strut.
13. Install the wheel.
14. Lower the vehicle.
15. Connect the battery.