Tools and materials:
* New outboard bearing
* Set of keys
* Jack and stands
*WD-40 or other penetrating lubricant
* Torque wrench (optional)
Procedure:
1. Place the vehicle in park and apply the parking brake.
2. Raise the car using a jack and place it on stands. Make sure the vehicle is securely secured.
3. Remove the terminal from the battery. This is a precaution to prevent short circuits.
4. Locate the hanger bearing on the driveshaft. It is located approximately halfway between the transmission and rear differential.
5. Treat the bolts securing the bearing with penetrating lubricant. Let it sit for a few minutes.
6. Unscrew the bolts. If you don’t have a torque wrench, hand-tighten the bolts as much as possible.
7. Remove the bearing from the shaft. You may need to tap it with a hammer or use a puller. Be careful not to damage the shaft.
8. Lubricate the new bearing. Apply some grease to the shaft where the new bearing will be installed.
9. Place the new bearing onto the shaft. Make sure it is seated correctly.
10. Install the bolts and tighten them. Use a torque wrench if you have one and tighten the bolts to the specified torque.
11. Connect the battery terminal.
12. Lower the vehicle.
13. Check the fluid level in the gearbox. Add fluid if necessary.
Adviсe:
* It is better to replace the outboard bearing with two people, since the shaft is heavy and it is inconvenient for one person to hold it.
*If a bearing is worn, it may show cracks, rust, or other damage.
* Bearing lubrication is necessary to prevent premature wear.
*After replacing the bearing, the driveshaft may need to be adjusted. This can be done by a mechanic using special tools.