Materials:
* New automatic transmission illumination lamp (TYC 3400402-01)
* Phillips screwdriver
Instructions:
1. Disconnect the negative terminal of the battery. This will prevent any electrical shock during operation.
2. Move the automatic transmission selector to neutral position.
3. Locate the automatic transmission switch panel. It is located on the center console.
4. Remove the automatic transmission switch panel. To do this, unscrew the two Phillips screws at the top of the panel. Then pull the panel straight towards you to remove it.
5. Find the automatic transmission illumination lamp. It will be located on the upper side of the automatic transmission selector.
6. Disconnect the lamp. Press the lamp latch and pull the lamp straight down to remove it from the socket.
7. Install a new lamp. Insert the new lamp into the socket until it clicks. Make sure the lamp is installed correctly for it to work.
8. Reinstall the automatic transmission switch panel. Insert two screws into the top of the panel and tighten them.
9. Connect the negative terminal of the battery.
10. Check lamp operation. Move the automatic transmission selector to different positions and check if the lamp lights up.
Adviсe:
* Be careful when removing the automatic transmission switch panel as wires may be attached to it.
* Do not touch the new lamp with bare hands as this may reduce its lifespan.
* If the new lamp does not work, check its connection or try replacing it with another one.