Required tools and materials:
* New starter
* 12mm wrench
* 14mm wrench
* 17mm wrench
* Flat head screwdriver
The procedure for replacing the starter on a Hyundai Accent automatic transmission:
1. Disconnecting the battery
* Disconnect the negative cable from the battery using a 10mm wrench.
2. Identification of the starter
* Look under the hood and locate the starter. It is usually located at the rear of the engine, near the flywheel.
3. Disconnecting wires
* Disconnect the positive starter cable with a 10mm wrench.
* Disconnect the small connector using a flathead screwdriver.
4. Unscrewing the starter
* Unscrew the starter mounting bolts with a 14 mm wrench.
5. Starter support
* Carefully support the starter with one hand to prevent it from falling.
6. Removing the starter
* Carefully remove the starter from the engine compartment.
7. Installing a new starter
* Insert the new starter into the seat.
* Tighten the mounting bolts with a 14mm wrench.
8. Connecting wires
* Connect the small connector.
* Connect the starter positive cable and tighten the nut with a 10mm wrench.
9. Battery connection
*Connect the negative cable to the battery with a 10mm wrench.
10. Checking the starter operation
* Start the engine to check the operation of the new starter. If the engine starts normally, the replacement is successful.