Required tools and materials:
* Wrench set
* Hex keys
* Hammer
* Screwdrivers
* Torque wrench
* New automatic transmission shank bearings
* Transmission sealant
* Rags or paper towels
Instructions:
1. Preparation:
* Remove the automatic transmission from the vehicle and disconnect all electronic connectors and connections.
* Disconnect the drive shaft and drive shaft spacer.
2. Dismantling old bearings:
* Knock out the old bearings from the transmission housing using a hammer and a suitable rod or drift.
* Be careful not to damage the transmission housing.
3. Cleaning and inspection:
* Thoroughly clean the transmission housing of dirt and debris.
* Inspect the housing and bearings for damage or wear.
4. Installation of new bearings:
* Lubricate the inner race of the new bearings with transmission sealant.
*Insert the new bearings into the transmission housing by hand or using a bearing driver.
* Make sure the bearings are completely seated in the housing.
5. Bearing tightening:
* Tighten the bearing nuts using a torque wrench to manufacturer specifications.
* Typically, tightening of bearings requires a force in the range of 150-250 Nm.
6. Assembly:
* Connect the drive shaft and drive shaft spacer.
* Reinstall the automatic transmission on the car and connect all connectors and connections.
7. Check:
* Start the engine and check for noise or vibration from the automatic transmission tail.
* Check the transmission fluid level and add it if necessary.
Adviсe:
* When operating, use new bearings and transmission sealant.
* Be careful not to over-tighten the bearing nuts.
* After replacing bearings, it is recommended to drive a short distance to check their operation.
*If you have any problems or questions during this procedure, contact a qualified mechanic.