Materials:
* New oil seal for the right automatic transmission axle shaft
* Transmission oil for automatic transmission
* Automatic transmission pan gasket
* O-ring for automatic transmission drain plug
* Cleaning products
Tools:
* Wrench set
* Hex key
* Jack and stands
* Puller for axle shafts
* Socket with sprocket
* Metal brush
* Funnel
* Oil drain container
Steps:
1. Remove the right front wheel. Place a jack and stands under the car. Remove the wheel.
2. Disconnect the steering rod from the steering knuckle. Use a hex wrench to loosen the pinch bolt. Then disconnect the tie rod from the steering knuckle.
3. Remove the brake caliper. Unscrew the caliper mounting bolts and carefully remove it from the brake disc. Hang the caliper on a wire or secure it to the shock absorber strut.
4. Remove the steering knuckle. Remove the steering knuckle bolts and carefully slide the drive shaft out of the hub. Then remove the steering knuckle.
5. Remove the drive shaft from the gearbox. Use an axle shaft puller to remove the drive shaft from the transmission.
6. Replace the oil seal. Carefully pry the old oil seal out of its seat and insert the new one. Make sure it is securely installed and not warped.
7. Install the drive shaft. Insert the drive shaft into the transmission and make sure it fits snugly against the oil seal.
8. Install the steering knuckle. Lift the steering knuckle and align it with the drive shaft. Install the steering knuckle mounting bolts.
9. Install the brake caliper. Install the brake caliper onto the brake disc and tighten the mounting bolts.
10. Connect the tie rod. Insert the tie rod into the steering knuckle and tighten the pinch bolt.
11. Install the wheel. Install the wheel and tighten the mounting bolts.
12. Drain and replace the automatic transmission oil. Using a container, drain the oil from the automatic transmission through the drain plug. Replace the O-ring on the drain plug. Fill the automatic transmission with new oil using a funnel.
13. Install a new gasket on the automatic transmission pan. Clean the surface of the pan and install a new gasket.
14. Install the automatic transmission pan. Reinstall the automatic transmission pan and tighten the fastening bolts.
15. Start the engine and check for leaks. Start the engine and shift the automatic transmission selector to all positions. Check under the vehicle for leaks.
16. Check the oil level in the automatic transmission. With the engine running and the automatic transmission selector in neutral, check the oil level using the dipstick. Add oil if necessary.