Required tools and materials:
* Wrench set
* 15 mm hex key
* Hub nut wrench
* Hammer
* Chisel
* Hook or screwdriver
* New drive seal
Steps to replace the drive seal:
1. Preparation:
* Place the vehicle on a level surface and apply the parking brake.
* Remove the left front wheel.
2. Disconnecting the drive:
* Loosen the hub nuts.
* Disconnect the tie rod from the steering knuckle.
* Disconnect the drive from the gearbox.
3. Removing the old oil seal:
*Locate the old oil seal located at the end of the drive shaft where it enters the transmission.
* Use a hook or screwdriver to carefully pry out the seal.
* Use a hammer and chisel to carefully knock out the oil seal.
4. Installing a new oil seal:
* Apply a thin layer of grease to the outer edge of the new oil seal.
* Insert the new oil seal into the seat in the gearbox.
*Use a 15mm hex wrench to tighten the clamp nut.
*Tighten the nut to the torque specified in the instruction manual.
5. Re-installation of the drive:
* Insert the drive back into the gearbox and secure it.
* Connect the tie rod to the steering knuckle.
* Tighten the hub nuts to the specified torque.
6. Wheel installation and inspection:
* Install the wheel and lower the car.
* Tighten the wheel nuts to the specified torque.
* Check the transmission fluid level and add if necessary.
7. Check for leaks:
* Start the engine and let it warm up.
* Check for transmission fluid leaks from the new oil seal.
Adviсe:
* Use a quality oil seal.
*Clean the seat thoroughly before installing a new oil seal.
* Do not use excessive force when removing or installing the oil seal.
*If you are unsure of your abilities, seek help from a professional mechanic.