Materials:
* New light bulbs (12V, T5 or neon bulb)
* Flat head screwdriver
Instructions:
1. Disconnect the battery.
* Open the hood and disconnect the negative (-) battery cable.
2. Remove the automatic transmission selector panel.
*Locate and press the unlock button located on the top of the selector panel.
* Gently pull the selector panel straight towards you.
3. Disconnect the electrical connector.
* Locate the electrical connector connected to the rear of the selector panel.
* Press the latch and disconnect the connector.
4. Remove the light bulbs.
* Remove old light bulbs from sockets.
*Use a flathead screwdriver to carefully pry and remove the bulbs.
5. Install new light bulbs.
*Insert new light bulbs into sockets.
* Make sure they are installed correctly and the contacts are free of rust or dirt.
6. Connect the electrical connector.
* Connect the electrical connector to the rear of the selector panel.
* Make sure it is securely fastened.
7. Install the automatic transmission selector panel.
* Align the selector panel and carefully insert it into the installation location.
*Press it until it clicks into place.
8. Connect the battery.
* Connect the negative (-) battery cable.
Examination:
* Start the engine and check if the automatic transmission selector lights come on.
* Switch the selector to different positions and make sure that the corresponding light is on.