Required materials and tools:
* New set of automatic transmission drive oil seals
* Transmission fluid
* Automatic transmission pan gasket
* Sealant for automatic transmission
* Extension with joint
* Adjustable wrench
* Hex keys
* Torque wrench
* Lift or jacks
* Drain pan
* Rags or paper towels
Instructions:
1. Preparation
* Raise the car and secure it on supports.
* Remove the wheel from the side where you will be replacing it.
2. Draining transmission fluid
* Find the drain plug on the automatic transmission pan and place a drain pan under it.
* Loosen the drain plug and drain the transmission fluid.
3. Removing the drive shaft
* Disconnect the guide rod from the shock absorber strut.
* Remove the hub nut.
* Pull the drive shaft out of the hub.
* Remove the drive shaft from the automatic transmission.
4. Replacing oil seals
* Carefully pry and remove the old oil seal from the drive shaft.
* Wet the new oil seal with transmission fluid and carefully push it into place.
*Use a suitable extension with a hinge to fully seat the seal.
5. Installation of the drive shaft
* Insert the drive shaft back into the automatic transmission.
* Make sure the oil seal is properly installed and lubricated.
* Tighten the hub nut with a torque wrench according to the manufacturer’s instructions.
6. Installation of the guide tip
* Attach the guide rod to the shock absorber strut.
7. Filling with transmission fluid
* Add new transmission fluid to the automatic transmission through the filler tube.
* Check the fluid level with the dipstick and add more if necessary.
8. Installing the automatic transmission pan
* Replace the automatic transmission pan gasket.
* Apply automatic transmission sealant to the new gasket.
* Install the automatic transmission pan and tighten the bolts with a torque wrench.
9. Starting the engine and checking the fluid level
* Start the engine and let it idle.
* Shift all gears and check for leaks.
* Check the fluid level on the dipstick after the engine has cooled. Add liquid if necessary.
10. Wheel installation
* Reinstall the wheel and tighten the bolts.
* Lower the vehicle and remove the supports.
Adviсe:
* Clean the drive shaft and automatic transmission housing before installing new oil seals.
*Use only high quality seals and transmission fluid recommended for your vehicle model.
* Check the fluid level regularly, especially after replacing the seals.