Required tools and materials:
* Wrench set
* Screwdriver set
* Oil seal remover
* New seals
*WD-40 or similar lubricant
* Gloves
Stages of replacing oil seals for Hyundai Accent Tagaz automatic transmissions:
1. Preparation
* Set the car to the parking brake.
* Place chocks under the wheels.
* Raise the car using a jack and place it on supports.
2. Removing the wheel and axle shaft
* Unscrew the wheel nuts.
* Remove the wheel.
* Unscrew the hub nut and remove the hub along with the brake disc.
* Unscrew the bolts securing the axle shaft to the hub and remove the axle shaft.
3. Removing the old oil seal
* Insert the oil seal puller into the hole where the oil seal is installed.
* Pull the puller to remove the old oil seal.
4. Surface cleaning
* Clean the surface around the oil seal hole from dirt and grease.
5. Installing a new oil seal
* Apply a thin layer of WD-40 to the inside of the new oil seal.
* Insert the new oil seal into the hole using a mandrel or hammer.
* Make sure the oil seal is completely seated in the hole.
6. Installation of axle shaft and wheel
* Install the axle shaft onto the hub and tighten the bolts.
* Install the hub together with the brake disc.
* Install the wheel and tighten the wheel nuts.
7. Check
* Lower the car.
* Check for transmission fluid leaks from the seals.
Features of replacing oil seals for Hyundai Accent Tagaz automatic transmissions:
* It is important to use only original oil seals or high quality analogues.
* During replacement, do not damage the surface of the axle shaft or hub.
* Tighten bolts and nuts to the specified torque.
* After replacing the seals, it is recommended to check the transmission fluid level in the automatic transmission and, if necessary, add fluid.