Materials you will need:
* Automatic transmission inhibitor (catalog number: MR373713)
* New O-ring (part number: 2920A039 or equivalent)
* Transmission fluid ATF SP-III (according to the volume specified in the operating manual)
* Tool set (ratchet, wrenches, etc.)
* Container for collecting old transmission fluid
* Funnel
Procedure for replacing the automatic transmission inhibitor:
1. Remove the negative terminal from the battery.
2. Raise the vehicle on a lift or support it on both sides.
3. Find an automatic transmission inhibitor. It is located on the left side of the transmission, next to the gear lever.
4. Unscrew the bolts securing the inhibitor to the gearbox.
5. Carefully remove the inhibitor. Be careful not to damage the O-ring.
6. Remove the O-ring from the inhibitor.
7. Install a new O-ring on the new inhibitor.
8. Apply a small amount of transmission fluid to the O-ring.
9. Install a new inhibitor on the transmission.
10. Tighten the inhibitor mounting bolts.
11. Connect the negative terminal of the battery.
12. Check the transmission fluid level and add if necessary.
13. Start the engine and shift through all gears to ensure that the inhibitor is operating correctly.
Adviсe:
* Disconnect the electrical connector before removing the inhibitor.
*Pay attention to the position of the inhibitor before removal to ensure proper installation.
* Use only original ATF SP-III transmission fluid.
* Check the fluid level after driving for some time to make sure it is not below the required level.