Materials:
* New automatic transmission handle
*Torx T30 screwdriver
* Plastic trim removal tool
Steps:
1. Remove the protective panel:
*Using a T30 Torx screwdriver, remove the two screws holding the bezel in place around the shift lever.
* Gently pull the panel towards you to remove it.
2. Disconnect the electrical connector:
* Locate the electrical connector at the bottom of the shift lever.
* Press the latch and disconnect the connector.
3. Unscrew the bolt:
* Locate the bolt that holds the shift knob in place.
*Use a T30 Torx screwdriver to remove this bolt.
4. Remove the old handle:
* Pull up on the old shift knob to remove it from the shift lever.
5. Install the new handle:
* Align the new automatic transmission handle with the gear shift lever.
*Press the handle to secure it.
6. Tighten the bolt:
*Use a T30 Torx screwdriver to tighten the bolt holding the new shift knob in place.
7. Connect the electrical connector:
* Connect the electrical connector to the new automatic transmission handle.
8. Install the protective panel:
* Reinstall the protective panel.
* Tighten two T30 Torx screws to secure the panel.
Completion:
Check that the automatic transmission handle is installed correctly by shifting gears. Adjust as necessary to ensure smooth and correct gear shifting.