Materials:
* New automatic transmission cushion
* 13 mm wrench
* Flat head screwdriver
* 19 mm tube wrench
Instructions:
1. Ensure safety: Set the parking brake. Install wheel chocks under the wheels. Disconnect the negative battery terminal.
2. Find the automatic transmission mount: It is located under the automatic transmission, between it and the subframe.
3. Loosen the mounting bolts: Using a 13 mm wrench, loosen the mounting bolts of the cushion. Do not unscrew them completely.
4. Support the automatic transmission: Using a jack, carefully lift the automatic transmission to remove the load from the mount.
5. Unscrew the mounting bolts: Completely unscrew the mounting bolts of the pillow.
6. Remove the old cushion: Using a flat-head screwdriver, carefully pry the old cushion out of its seat.
7. Clean the seat: Clean the seat of dirt and debris.
8. Install the new cushion: Insert the new cushion into the seat.
9. Tighten the mounting bolts: Tighten the mounting bolts with a 13 mm wrench.
10. Install the protective cover: If the cushion has a protective cover, install it in place.
11. Lower the automatic transmission: Slowly lower the automatic transmission until it reaches its original position.
12. Check the tightness of the bolts: Check the tightness of the mounting bolts with a 13 mm wrench.
13. Connect the battery: Connect the negative terminal of the battery.
14. Lower the vehicle: Lower the vehicle from the jack.
Adviсe:
* It is recommended to replace the automatic transmission mount in pairs.
* When replacing an automatic transmission mount, it is also recommended to check the condition of other engine mounts and, if necessary, replace them.
*If you don’t have access to a lift or jack, you can raise your car using a sturdy wooden support.
* Be careful when handling the jack and always ensure it is stable.