Required tools and materials:
* New automatic transmission cable
* Wrench set
* Pliers
* WD-40 or similar spray lubricant
* Extra pair of hands (optional)
Steps to replace the automatic transmission cable:
1. Disconnect the battery: Disconnect the negative battery cable to prevent electrical shock.
2. Raise the vehicle: Raise the vehicle on a lift or jack, making sure it is securely supported.
3. Locate the cable: The automatic transmission cable is usually located on the side of the engine, running from the gear selector to the transmission.
4. Disconnect the cable from the gear selector: Loosen the nut or bolt connecting the cable to the gear selector and disconnect the cable.
5. Disconnect the cable from the transmission: Remove the bracket or latch holding the cable to the transmission and disconnect the cable.
6. Remove the old cable: Pull the old cable through the engine compartment and remove it completely.
7. Install New Cable: Thread the new cable through the engine compartment, following the same path as the old cable.
8. Connect the cable to the transmission: Secure the new cable to the transmission using a bracket or clip.
9. Connect the cable to the gear selector: Connect the cable to the gear selector and tighten the nut or bolt.
10. Adjust the cable: Adjust the cable so that the gear selector moves smoothly and engages gears correctly. This can be done using an adjusting bolt or nut on the cable.
11. Lubricate the cable: Apply a coat of WD-40 or similar spray to the cable to ensure smooth operation.
12. Tighten all connections: Make sure all cable connections are securely tightened.
13. Check operation: Charge the battery, start the engine and check that the gear selector shifts smoothly and engages the gears correctly.
Adviсe:
*If you have no experience working on transmissions, it is recommended that you take this task to a professional mechanic.
*Before starting work, mark the position of the cable on the gear selector and transmission to facilitate re-installation.
* Replace the transmission cable according to the recommended maintenance interval or when any shifting problems occur.