Replacing the rear engine mount on a Lada Granta automatic transmission
Required tools and materials:
* Jack
* Stands
* Set of keys
* Extensions
* Torque wrench
* New rear engine mount
Instructions:
1. Ensure safety: Apply the parking brake and park the vehicle on a level surface.
2. Raise the car: Raise the rear of the car with a jack and support it with stands.
3. Remove the crankcase protection: If installed, remove the crankcase protection by unscrewing the mounting bolts.
4. Locate the rear engine mount: It is located under the transmission.
5. Loosen the mounting bolts: Loosen the engine mounting bolts using a wrench.
Note: Do not unscrew the bolts completely.
6. Support the Transmission: Use a jack or stand to lightly support the transmission on the side where the cradle is located.
7. Unscrew the mounting bolts: Unscrew the mounting bolts of the engine mount and remove it.
8. Clean the seat: Clean the seat on the gearbox and on the pad from dirt and debris.
9. Install a new mount: Install the new rear engine mount into the seat.
10. Tighten the mounting bolts: Tighten the engine mount mounting bolts to 60 Nm using a torque wrench.
11. Lower the vehicle: Lower the vehicle from the jack and remove the jack stands.
12. Tighten the sump guard bolts: If you removed the sump guard, reinstall it and tighten the bolts.
Adviсe:
*Use a good quality new engine mount.
* Tighten the mounting bolts in the correct sequence and to the specified torque.
* Check the condition of other engine mounts when replacing the rear one.
* After installing a new engine mount, it is recommended to start the engine and check its operation for vibrations.