Materials and tools:
* 10 mm wrench
* 13 mm wrench
* 15 mm wrench
* 17 mm wrench
* 19mm wrench
* Ratchet wrench
* Heads for 10 mm, 13 mm, 15 mm, 17 mm, 19 mm
* Large wrench
* Key extensions
* Flathead and Phillips head screwdrivers
* Jack
* Car stands
* Automatic transmission fluid container
* New automatic transmission pan gasket
* New automatic transmission oil (if necessary)
Instructions:
1. Place the vehicle on a level surface and apply the parking brake.
2. Jack up the front of the vehicle and place stands under the front suspension arms.
3. Drain the automatic transmission fluid into a prepared container. To do this, unscrew the drain plug of the automatic transmission pan.
4. Remove the caps from the front wheel hub nuts.
5. Unscrew the hub nuts, but not completely.
6. Using a large screwdriver or lever, disconnect the steering knuckles from the steering knuckles.
7. Remove the front wheels.
8. Unscrew the bolts securing the lower arms to the subframe and remove the arms.
9. Disconnect the anti-roll bar link from the subframe.
10. Unscrew the bolts securing the subframe to the body and lower the subframe.
11. Disconnect the drive shafts from the transmission and secure them with wire so that they do not interfere.
12. Disconnect the hydraulic lines from the transmission and plug them to prevent fluid leakage.
13. Unscrew the starter mounting bolts and remove it.
14. Disconnect the connectors from the solenoid valves and sensors located on the transmission.
15. Unscrew the bolts securing the torque converter to the flywheel.
16. Carefully separate the transmission from the engine using a crowbar or lever.
17. Remove the gearbox from under the vehicle.
Gearbox Installation
To install the gearbox, perform the above steps in reverse order:
1. Reinstall the gearbox.
2. Screw in the torque converter mounting bolts.
3. Connect hydraulic lines.
4. Screw in the starter mounting bolts.
5. Connect the connectors to the solenoid valves and sensors.
6. Install the subframe and tighten the mounting bolts.
7. Connect the anti-roll bar link to the subframe.
8. Install the lower arms and tighten the mounting bolts.
9. Install the steering knuckles on the steering knuckles.
10. Install the front wheels and tighten the wheel nuts.
11. Fill the automatic transmission fluid to the recommended level.
12. Remove the vehicle from the stands and lower it to the ground.