Tools and materials:
* New drive seal
* Set of keys
* Flat head screwdriver
* Rags
Instructions:
1. Set the vehicle to the parking brake and chock the front wheels.
2. Raise the front of the car from the right side and place it on stands.
3. Remove the right front wheel.
4. Clean the surface around the oil seal.
5. Using a flathead screwdriver, carefully pry up the old oil seal and remove it.
6. Apply a thin layer of sealant to the outer edge of the new oil seal.
7. Insert the new oil seal into the socket using a mandrel or suitable tool. Make sure that the seal is installed correctly and protrudes beyond the edge of the socket by approximately 1 mm.
8. Reinstall the drive.
9. Install the wheel and tighten the bolts.
10. Remove the vehicle from the stands and lower it to the ground.
11. Start the engine and check for leaks. If necessary, tighten the drive bolts.
Adviсe:
* Use original Opel drive oil seal.
* Maintain cleanliness during operation to prevent dirt from entering the drive.
*If you are unsure of your skills, ask a mechanic for help.