Materials:
* New gear oil (1.7-1.9 liters)
* Oil pan gasket (if necessary)
* New oil filter (if necessary)
* Funnel
* 10 mm wrench
* 13 mm wrench
* 8 mm hex key
Instructions:
1. Preparing the car:
* Place the car on a level surface.
* Apply the parking brake.
* Allow the engine and transmission to cool for 30 minutes.
2. Draining old oil:
* Place a container under the car to collect the oil.
* Locate the transmission oil pan drain plug.
* Loosen the drain plug with a 13 mm wrench and drain the oil into a container.
* Install the drain plug with a new gasket (if necessary).
3. Replacing the oil filter:
*Locate the oil filter on the side of the transmission.
* Carefully unscrew the oil filter by hand.
* Apply a small amount of new oil to the O-ring of the new filter.
* Screw the new oil filter into place by hand, then tighten it with an 8mm wrench about a quarter turn.
4. Filling with new oil:
*Locate the filler plug on the top of the transmission.
* Unscrew the filler plug with a 10 mm wrench.
*Using a funnel, pour new gear oil into the gearbox. Fill with the recommended amount of oil (see your vehicle’s owner’s manual).
5. Checking the oil level:
* Start the engine and let it idle for a few minutes.
* Shift through each gear and back into park.
* Stop the engine and wait a few minutes for the oil to drain back into the oil pan.
* Check the oil level by inserting the dipstick into the filler hole. The oil level should be between the «MIN» and «MAX» marks on the dipstick. Top up if necessary.
6. Resetting the oil change counter:
* Turn on the ignition.
*Press and hold the odometer reset button (usually located on the dashboard or steering wheel).
* Press the engine start button and release.
*Hold the odometer reset button until the oil change meter reset message appears on the instrument panel.
Note:
* Dispose of old oil and oil filter in accordance with local environmental regulations.
*If you are unsure of your skills, it is recommended that you seek assistance from a qualified mechanic.