Required tools and materials:
* New resistor automatic transmission Nissan Note
* Wrenches 10, 12, 14 mm
* Phillips screwdriver
* Rags
Step by step instructions:
1. Preparing the car
* Turn off the engine and put the car on the parking brake.
* Disconnect the negative terminal of the battery.
2. Removing the resistor connector
* Locate the automatic transmission resistor, which is usually located near the gearbox.
* Disconnect the resistor connector by pressing the latch.
3. Unscrewing the nut
*Using a 14mm wrench, remove the nut holding the resistor to the gearbox.
4. Removing the old resistor
* Pull the resistor lightly to remove it from its seat.
5. Installing a new resistor
* Insert the new resistor into the slot on the gearbox.
6. Tightening the nut
*Tighten the nut holding the resistor in place using a 14mm wrench.
7. Connector connection
* Connect the resistor connector to the connector on the transmission.
8. Installing the battery terminal
* Connect the negative terminal of the battery.
9. Reset adaptation
* Start the engine and let it idle for a few minutes.
* Switch the automatic transmission selector to different positions and return to the parking position.
* Turn off the engine and wait a few minutes before starting it again.
Checking work:
* Start the engine and check if the automatic transmission shifts smoothly. If any problems occur, contact a qualified mechanic.