Materials:
* Automatic transmission oil coolers
* Hoses and clamps
* Keys and screwdrivers
* Cleaning solvent
* Anti-seize paste
Tools:
* Set of keys
* Pliers
* Oil filter wrench
* Lift or jack
Steps:
1. Preparing the car:
*Remove the lower bumper or protective cover, if equipped.
* Drain the automatic transmission fluid.
2. Removing old radiators:
* Disconnect the hoses going to the radiators.
* Remove the bolts securing the radiators.
* Remove radiators from their place.
3. Surface cleaning:
* Clean the surfaces where new radiators will be installed using solvent.
4. Installation of new radiators:
* Apply anti-seize paste to radiator O-rings.
* Reinstall the radiators and tighten the bolts.
* Connect the hoses to the radiators and tighten the clamps.
5. Filling and bleeding the automatic transmission:
* Fill the automatic transmission with fluid.
* Start the engine and let it idle.
* Shift the gear lever to each position and return to the park position.
* Check the fluid level and add if necessary.
6. Final stage:
* Reinstall the lower bumper or protective cover.
* Check the system for leaks.
Additional tips:
* It is recommended to use radiators of the same type and size as the original ones.
*Before installing new radiators, thoroughly clean the cooling system to remove contaminants.
* Use high quality hoses and clamps to prevent leaks.
* After installing the radiators, it is recommended to flush the automatic transmission to remove any remaining contaminants.
* Don’t forget to calibrate the automatic transmission temperature sensors after installing new radiators.