Materials:
* Additional automatic transmission cooling radiator
* Thermostat
* Pipelines and fittings
* Clamps
* Transmission fluid
* Funnel
Tools:
* Wrench
* Flat head and Phillips head screwdriver
* Pliers for removing clamps
* Transmission fluid bleeder pump (optional)
Steps:
1. Preparation:
* Make sure you have all the necessary materials and tools.
* Disconnect the battery.
* Raise the car using jacks and secure it with support stands.
2. Removing the automatic transmission main pipelines:
* Locate the automatic transmission main pipelines running from the gearbox to the radiator.
* Loosen the clamps that secure them.
* Remove the pipelines.
3. Thermostat installation:
* Install the thermostat according to the manufacturer’s instructions.
* Usually the thermostat is installed between the radiator and the main pipelines of the automatic transmission.
4. Installation of an additional radiator:
* Find a suitable location to install the additional radiator.
* It is usually installed in front of the main radiator.
* Secure the radiator using the included fasteners.
5. Pipe connection:
* Connect the main pipelines to the thermostat and additional radiator.
* Tighten the clamps to ensure tight connections.
6. Filling the system:
* Fill the system with fresh transmission fluid using a funnel.
* Make sure the fluid level is within the recommended range.
7. Bleeding the system (optional):
*If you have a transmission fluid pump, use it to bleed the system.
* This will help remove air and ensure proper fluid circulation.
8. Checking the fluid level:
* Start the engine and run it in park or neutral.
* Check the fluid level in the automatic transmission using a dipstick.
*Add fluid if necessary.
9. Test ride:
* Take a short test drive to check the operation of the automatic transmission cooling system.
* Watch for signs of overheating or leaks.
10. Final check:
*After a test drive, check the fluid level and visually inspect the system for leaks.
* Tighten any loose clamps or connections.
Adviсe:
* Use quality transmission fluid recommended by the manufacturer.
* Periodically check the fluid level in the automatic transmission, especially after installing an additional radiator.
* Flush and bleed radiators regularly to ensure maximum cooling efficiency.
*If you are unsure of any steps, seek help from a professional mechanic.