Materials:
* New automatic transmission filter
* Automatic transmission pan gasket
* Transmission fluid (as needed)
* Tool set
Instructions:
1. Remove the engine protection and automatic transmission pan:
— Unscrew the screws holding the engine protection and remove it.
— Unscrew the bolts around the perimeter of the automatic transmission pan and carefully remove the pan. Drain the oil into a prepared container.
2. Remove the old filter:
— Clean the pan from the remains of the old filter.
— Find the old filter and remove it from the automatic transmission housing.
3. Install a new filter:
— Make sure the surface of the filter housing is clean.
— Install the new filter into the housing, aligning it correctly.
4. Replace the pan gasket:
— Clean the surfaces of the pan and the automatic transmission housing from the old gasket.
— Install a new gasket on the pan.
5. Reinstall the tray:
— Lift the tray and place it in place. Tighten the bolts to the proper torque.
— Reinstall the engine protection.
6. Fill with transmission fluid (if necessary):
— If you also changed the transmission fluid, now is the time to refill it. Use the dipstick to check the fluid level.
7. Reset the error code (if any):
— If the error light comes on while replacing the filter, you need to reset the error code using an OBD2 scanner.
8. Check for leaks:
— Start the engine and check for transmission fluid leaks.
Adviсe:
*Use only the recommended type of filter and transmission fluid.
* Tighten the bolts to the specified torque.
* Do not overtighten the bolts, otherwise this may damage the pan or automatic transmission housing.
*If you are unsure of your mechanical skills, consult a qualified mechanic.