Steps to repair the valve body of a Hyundai Solaris automatic transmission:
Tools and materials:
* Tool set for automatic transmission
* New gaskets and seals
* Valve block automatic transmission Hyundai Solaris
* Transmission fluid
* Automatic transmission filter
Instructions:
1. Removing the valve body:
* Remove the automatic transmission pan and drain the transmission fluid.
* Disconnect the wiring harnesses and valve body cooling pipes.
* Unscrew the bolts securing the valve body to the automatic transmission housing.
* Remove the valve body.
2. Disassembly and inspection of the valve body:
* Disassemble the valve body by removing all solenoids, springs and gaskets.
* Inspect all components for signs of wear or damage.
* Check the condition of the valve body channels and make sure they are clean and not clogged.
3. Replacement of damaged components:
* Replace any damaged or worn components with new ones.
* Install new gaskets and seals.
4. Valve block assembly:
* Assemble the valve body by installing all components in the correct order.
* Make sure all solenoids and springs are installed correctly.
5. Installation of the hydraulic unit:
* Install the valve body on the automatic transmission housing.
* Attach it with bolts and tighten them to the appropriate torque.
* Connect the wiring harnesses and cooling pipes.
6. Installing the automatic transmission pan:
* Install the automatic transmission pan and secure it with bolts.
* Fill with new transmission fluid.
7. Replacing the automatic transmission filter:
* Remove and replace the automatic transmission filter.
8. Completion:
* Check the transmission fluid level and add if necessary.
* Start the engine and check the operation of the automatic transmission.
*Take a test drive to ensure that the automatic transmission operates properly.
Notes:
* Repairing an automatic transmission valve body is a complex procedure that should only be performed by qualified specialists.
* Use only original spare parts or high-quality analogues.
* Observe all tightening torques during assembly and installation.
* After repair, it is recommended to reset the automatic transmission adaptations using a diagnostic scanner.