Required tools and materials:
* Set of socket wrenches
* Flat head screwdriver
* Sealant for automatic transmission
* DOT3 or DOT4 brake fluid
* Neue automatic transmission gasket
Replacement steps:
1. Preparation
* Place the car on a flat surface.
* Disconnect the battery.
* Remove the engine protection (if equipped).
2. Drain the brake fluid
* Locate the brake fluid reservoir in the engine compartment.
* Open the lid and use a suction syringe to remove as much liquid as possible.
*Add new brake fluid to the minimum level.
3. Removing the automatic transmission
* Disconnect all electrical connectors and vacuum hoses from the automatic transmission.
* Unscrew the bolts securing the automatic transmission to the engine.
* Install a support under the automatic transmission.
* Carefully disconnect the automatic transmission from the engine.
4. Replacing the gasket
* Clean the surfaces of the automatic transmission and engine on which the new gasket will be installed.
* Apply automatic transmission sealant to the new gasket.
* Install the new gasket in place.
5. Automatic transmission installation
* Carefully install the automatic transmission into place.
* Tighten the bolts securing the automatic transmission to the engine.
* Connect all electrical connectors and vacuum hoses.
6. Filling brake fluid
*Add brake fluid to the reservoir to the maximum level.
* Bleed the brakes to remove air.
7. Reset fault codes
* Connect the battery.
* Start the engine and let it idle for a few minutes.
* Check the Check Engine Light for trouble codes and reset them if necessary.
8. Completion
* Check the brake fluid level and add if necessary.
* Reinstall the engine protection.
* Check the operation of the automatic transmission while driving.