Materials required to replace the automatic transmission filter in a Hyundai Matrix:

* Automatic transmission filter (part number: 46321-23000)
* Automatic transmission pan gasket (part number: 21513-23001)
*Transmission fluid (use your vehicle’s recommended fluid)
* Wrench set
* Pliers
* Oil pan
* Funnel

Instructions for replacing the automatic transmission filter in a Hyundai Matrix:

1. Preparation:

* Park the car on a level surface and turn off the engine.
* Raise the vehicle or use a lift to provide access to the automatic transmission.
* Place an oil pan under the automatic transmission to catch any draining fluid.

2. Draining transmission fluid:

* Locate the drain plug on the automatic transmission pan and loosen it with a wrench.
* Allow the transmission fluid to drain into the oil pan. Wait until the leak stops.

3. Removing the automatic transmission pan:

* Remove the bolts securing the automatic transmission pan.
* Carefully separate the pan from the automatic transmission.
* Be prepared for the possibility that additional transmission fluid may leak out when removing the pan.

4. Replacing the automatic transmission filter:

* Find and remove the old automatic transmission filter.
* Install the new filter in its place. Make sure it is installed correctly.

5. Installing the automatic transmission pan:

* Install a new automatic transmission pan gasket.
* Attach the pan back to the automatic transmission and tighten the bolts.

6. Filling with transmission fluid:

* Measure the amount of drained transmission fluid and pour the same amount into the automatic transmission.
*Use a funnel to add liquid.

7. Checking the fluid level:

* Start the engine and let it idle.
* Shift through all gears and return to park position.
* Turn off the engine and wait a few minutes.
* Check the fluid level on the automatic transmission dipstick. The level should be between the “HOT” and “COLD” marks on the dipstick.

8. Installation and assembly:

* Lower the vehicle and remove the jack or lift.
* Check for leaks and make sure all bolts are tight.

Adviсe:

* It is recommended to replace the automatic transmission filter every 30,000-40,000 kilometers or in accordance with the manufacturer’s recommendations.
* Cool the transmission fluid before draining to prevent burns.
*Use original parts to ensure reliable and long-lasting performance.
*If you are unsure of this procedure, it is recommended that you seek assistance from a qualified mechanic.

Leave a Reply