Required tools and materials:
* New automatic transmission temperature sensor
* Phillips screwdriver
* Pliers
* Soldering iron and solder (optional)
Replacement instructions:
1. Disconnect the battery: Disconnect the negative cable from the battery to prevent short circuit.
2. Locate the sensor: The automatic transmission temperature sensor is usually located on the transmission housing. Find it by following the wiring harness from the automatic transmission.
3. Disconnect the electrical connector: Locate the electrical connector connected to the sensor and disconnect it by squeezing the clips.
4. Remove the sensor: Using a Phillips screwdriver, remove the sensor from the transmission housing. Be careful not to damage the threads.
5. Install New Sensor: Take the new sensor and screw it into the transmission housing. Then tighten it using a Phillips screwdriver.
6. Connect the electrical connector: Connect the electrical connector to the sensor. Make sure it fits snugly.
7. Solder the connections (optional): To ensure better electrical contact, you can solder the connections between the sensor and the plug contacts.
8. Connect the battery: Connect the negative cable back to the battery.
9. Check operation: Start the vehicle and let it run for a few minutes. Then check if the problem with the automatic transmission temperature sensor has disappeared.
Adviсe:
* Use a sensor specifically designed for the Hyundai ix35 model.
* Clean the surface on which the sensor is located of any dirt or oil before installing a new sensor.
*Do not over-tighten the sensor as this may damage the threads or the sensor itself.
*If you are unsure of your skills, consult a qualified mechanic.