Automatic transmission brake band adjustment
Materials:
* Wrench set
* Dipstick
* Torque wrench
* Magazine paper
Setup steps:
1. Prepare the car
* Stop the engine.
* Put the car on the handbrake.
* Install wheel chocks under the rear wheels.
2. Warm up the transmission
* Start the engine and let it run for a few minutes.
* Shift all gears several times to warm up the transmission.
3. Adjust the tape
* Locate the brake band adjusting screw on the automatic transmission. It is usually located on the side or bottom of the transmission housing.
* Loosen the locknut on the adjusting screw.
*Using a wrench, tighten or loosen the adjustment screw until the dipstick engages the adjustment nut.
* Pull the dipstick and insert a small piece of magazine paper between the adjusting nut and the tape.
*Tighten the adjusting screw 1/8 to 1/4 turn until the paper is clamped between the nut and the tape.
* Take out the paper and tighten the lock nut.
4. Check the belt tension
*Using a torque wrench, tighten the brake band housing bolts to manufacturer specifications.
5. Reset your computer
* Disconnect the negative terminal of the battery for 5-10 minutes.
* Reconnect the battery terminal.
6. Check the transmission
* Start the engine and let it run.
* Shift all gears and check if the transmission shifts smoothly.
Note:
* Always follow the manufacturer’s instructions when adjusting the automatic transmission brake band.
* Incorrect adjustment may damage the transmission.
*If you are not experienced in servicing your transmission, it is recommended that you take it to a qualified mechanic.