Tools and materials:
* Wrench (size depends on the specific car model)
* Pliers
* Rags or rags
* Container for draining automatic transmission fluid
Instructions:
1. Ensure safety:
* Park the car on a level surface and apply the parking brake.
* Allow the engine to cool.
2. Find the tube on the radiator:
* Automatic transmission radiator pipes are usually connected to the top and bottom of the radiator.
* The tubes can be metal or rubber, and also have a connection in the form of clamps or threads.
3. Disconnect the radiator hoses (rubber):
* Use pliers to loosen the clamps on the radiator hoses.
* Remove the hoses from the tubes.
* Place a container under the hoses to drain the remaining automatic transmission fluid.
4. Unscrew the tube connections (metal):
* Use a wrench to remove the nuts or bolts that connect the pipes to the radiator.
* Be careful not to damage the threads.
5. Remove the tubes:
* When the connections are loose, gently pull the tubes to remove them from the radiator.
*Use rags or rags to catch any remaining liquid.
6. Clean and inspect the tubes and radiator:
* Clean the tubes and the area on the radiator where they were installed of any remaining fluid or debris.
* Inspect the tubes and radiator for damage or leaks.
7. Install new tubes:
* If the tubes are being replaced, insert the new tubes into the radiator.
* Tighten all connections properly using a wrench.
8. Connect the radiator hoses (rubber):
* Connect the radiator hoses to the pipes.
* Tighten the hose clamps with pliers.
9. Add automatic transmission fluid:
*Add transmission fluid to the correct level specified in your vehicle’s owner’s manual.
* Start the engine and let it run for a few minutes to bleed the fluid.
* Check the fluid level again and add if necessary.