Materials:
* Screwdriver with Torx T20 head
* Plastic wedge tool (optional)
Steps:
1. Put the car in park and turn off the ignition.
2. Remove the protective cover.
*Grip the back of the cover and pull it up to release the clips.
3. Remove two T20 Torx bolts.
* The bolts are located at the top of the panel, under the protective cover.
4. Carefully remove the shift pad.
* Pull the trim straight up to release its clips.
*If the clamps are tight, you can use a plastic wedge tool to help.
Reverse installation:
1. Install the gearshift pad in its place.
* Align the clips on the trim with the holes on the panel.
* Press down on the pad to lock it in place.
2. Install two T20 Torx bolts.
* Tighten the bolts to a torque of 4 Nm.
3. Replace the protective cover.
* Insert the clips on the cover into the corresponding holes on the panel.
* Press down on the cover to lock it in place.
Adviсe:
* Be careful when removing the trim to avoid scratching the panel.
*If the clamps get stuck, do not use excessive force as this may damage them.
*If you don’t have a plastic wedge tool, you can use a thin flathead screwdriver or credit card to release the clamps.