Materials:
* Phillips screwdriver
* Round nose pliers (optional)
Instructions:
1. Disconnect the battery:
* Open the hood and find the negative terminal of the battery.
* Loosen the negative pole nut with a Phillips screwdriver and remove the terminal.
2. Remove the frame around the selector:
* Pull the sides of the frame around the selector inward to release it.
* Lift the frame up and remove it.
3. Loosen the selector lever bolt:
* Locate the bolt that secures the selector lever to the rocker.
* Loosen the bolt with a Phillips screwdriver, but do not remove it completely.
4. Move the selector to the parking position:
* Press the brake pedal and move the selector to the Park (P) position.
5. Remove the unlock button:
*Locate the unlock button next to the selector lever.
* Press the button and pull up to remove it.
6. Remove the selector clamp:
* There may be a spring under the selector clamp. Using pliers or a screwdriver, carefully pull out the spring.
*Then press down on the clip and pull it down to remove it.
7. Remove the selector:
* Remove the selector from the rocker. You may have to wiggle it a little to get it to come out.
Assembly:
Follow the same steps in reverse to reassemble the selector.
Note:
* Be careful not to damage the selector spring or clamp.
* Be sure to tighten the selector lever bolt to the required torque.
* After assembly, check the operation of the selector by moving it through all positions.