Materials:
* Rags
* Flat head screwdriver
* Phillips screwdriver
Instructions:
1. Prepare the vehicle: Place the vehicle in park, set the parking brake and turn off the ignition.
2. Remove the gear selector housing:
— Use a flat-head screwdriver to pry up the plastic plug at the base of the selector and remove it.
— Unscrew the Phillips screws under the plug.
— Lift the selector housing and disconnect the backlight power connector.
3. Disconnect the lock button:
— Press the lock button on the end of the handle.
— Use a flat-head screwdriver to pry it off and remove it.
4. Unscrew the handle fastening:
— There is a plastic nut under the handle.
— Unscrew the nut with a wrench or pliers.
5. Remove the handle:
— Gently pull the handle up to remove it from the selector rod.
— Disconnect the electrical connector from the handle, if present.
Adviсe:
*Be careful not to scratch the car’s finish.
*If the handle nut is tight, use WD-40 or other lubricant to loosen it.
* When installing a new handle, make sure the nut is tightened securely.