Required materials:
*Brake fluid (manufacturer’s recommended)
* Transparent tube
* Container for draining liquid
* Socket wrench or socket and ratchet
* Wrench or adjustable wrench
Safety:
*Always wear personal protective equipment such as gloves and safety glasses.
* Make sure the vehicle is on a level surface and there is enough room under the hood to work.
Procedure:
1. Preparation:
* Gather all necessary materials.
* Open the hood and locate the brake fluid reservoir.
* Turn the ignition key to the “on” position, but do not start the engine.
2. Draining old brake fluid:
* Locate the rear right caliper (it’s usually closer to the engine).
* Loosen the top bleeder bolt (usually 10-12mm).
*Place the clear tube over the bolt and place the other end into the drain container.
* Press the brake pedal (do not release).
* If the bolt does not come off, you can use a lever (such as a wrench).
3. Adding fluid and pumping:
* While the brake pedal is still depressed, slowly unscrew the lower bleeder bolt about a quarter turn.
*Brake fluid will begin to flow out of the pipe.
* Tighten the lower bleeder bolt as soon as you see that all the old fluid has flowed out.
* Release the brake pedal.
*Repeat these steps until clean brake fluid comes out of the bottom bolt with no air bubbles.
4. Air release:
* Now bleed each caliper in the following sequence: rear right, rear left, front right, front left.
*Repeat steps 2 and 3 for each caliper.
5. Filling fluid and checking:
*Once all calipers have been bled, add brake fluid to the level indicated on the reservoir.
* Close the hood and start the engine.
* Check the brake pedal for elasticity and travel. The pedal should be firm with minimal travel.
6. Cleaning and checking:
* Wipe all brake connection points to remove any spilled fluid.
* Check the brake fluid level a few days after bleeding to ensure there are no leaks in the system.