Tools and materials:
* Brake fluid to manufacturer specification
* Open spanner or socket wrench of appropriate size
* Transparent tube (about 1m long)
* Bucket or container to collect old liquid
Instructions:
1. Prepare the vehicle: Turn off the engine, put the vehicle on the parking brake and chock the rear wheels.
2. Check the fluid level: Open the hood and locate the brake fluid reservoir. Check the fluid level and, if necessary, add to the “MAX” or “FULL” mark.
3. Open the bleeder valve: Locate the bleeder valve on the brake caliper of the furthest wheel from the master cylinder (usually the rear right or left). Clean the valve from dirt and put a transparent tube on it.
4. Apply the brake pedal: Have a helper press the brake pedal several times until it becomes firm.
5. Open the bleeder valve: An assistant must simultaneously press the brake pedal firmly and open the bleeder valve on the caliper.
6. Release the fluid: Hold the bleeder valve open until the fluid with air bubbles flows out of the tube.
7. Close the bleeder valve: As soon as the liquid stops flowing out with bubbles, close the bleeder valve.
8. Release the brake pedal: Have an assistant release the brake pedal.
9. Repeat for the remaining wheels: Follow steps 3-8 for the remaining three wheels, starting with the far one and gradually moving towards the front left.
10. Check the fluid level: After bleeding all the wheels, check the fluid level in the reservoir again. If necessary, top up to the “MAX” or “FULL” mark.
Adviсe:
*Only use brake fluid recommended by the vehicle manufacturer.
* Do not open the reservoir cap while bleeding to prevent air from entering.
*If no air seems to be coming out when bleeding, there may be serious air trapped in the system and you should contact a service center.
* Check your brakes regularly and bleed them as necessary to ensure optimal braking performance.