Materials and tools:
* Gearbox
* Engine
* Transmission fluid
* Transmission housing gasket
* Transmission housing bolts
* Wrench set
* Collar
* Extension cord
* Torque wrench
Steps:
1. Ensure safety: Disconnect the negative terminal of the battery and set the vehicle to the parking brake.
2. Raise the vehicle: Raise the vehicle using a jack and place safety stands underneath it.
3. Remove the transmission cartridge: Remove the bolts holding the oil pan in place and remove it. Remove the old gasket.
4. Install a new gasket: Place the new transmission housing gasket in place. Check that it is properly aligned.
5. Lift the transmission into place: Lift the transmission and install it onto the engine. Make sure the transmission input shaft is aligned with the crankshaft bore.
6. Tighten the transmission housing bolts: Using a torque wrench, tighten the transmission housing bolts. Observe the torque specified in the operating instructions.
7. Install the starter: Locate and install the starter. Tighten the starter bolts.
8. Connect Sensors and Wires: Connect all electrical sensors and wires to the transmission.
9. Fill with transmission fluid: Open the fill plug on the side of the transmission. Fill with the recommended amount and type of transmission fluid.
10. Lower the vehicle: Slowly lower the vehicle from the jack. Tighten the wheel bolts.
11. Connect the negative terminal of the battery: Connect the negative terminal of the battery.
12. Check the fluid level: Warm up the engine and check the transmission fluid level using the dipstick. Add liquid if necessary.
Adviсe:
* Before installing the transmission, it is recommended to clean the surfaces around the crankshaft bore and transmission flange.
*Use guide pins to facilitate alignment of the transmission and engine.
* Tighten bolts in the correct sequence and to the specified torque.
* Check all connections before operating the vehicle.