Materials and tools:
* New manual transmission
* Clutch
* Flywheel
* Release bearing
* Release bearing guide
* Gear shift lever
* Gear oil
* Jack
* Jack stands
* Wrench set
* Screwdrivers
* Hammer
Steps:
1. Security:
* Disconnect the battery by removing the negative terminal.
* Set the car to the handbrake.
* Raise the vehicle using a jack and place jack stands on secure support points.
2. Removing the automatic transmission:
* Drain the transmission oil from the automatic transmission.
* Disconnect all cables and electrical connectors from the transmission.
* Unscrew the bolts securing the gearbox to the engine.
* Unscrew the bolts securing the gearbox to the supports.
* Carefully remove the gearbox from its seat.
3. Installation of manual transmission:
* Install the flywheel on the crankshaft.
* Install the new release bearing into the guide.
* Install the clutch onto the flywheel.
* Attach the manual transmission to the engine.
* Attach the gearbox to the supports.
4. Installation of the gear shift lever:
* Install the gear shift lever in the passenger compartment.
* Connect the shift cable to the gearbox.
5. Connection:
* Connect all cables and electrical connectors to the transmission.
* Pour transmission oil into the gearbox.
6. Final assembly:
* Lower the car from the jack.
*Remove jack stands.
* Connect the battery.
* Bleed the clutch by pressing the pedal several times.
7. Test:
* Start the car and test the clutch operation.
* Shift gears to ensure proper operation.
Adviсe:
* Use quality parts and components.
* Carefully tighten all bolts and nuts to specifications.
*If you are unsure of your capabilities, seek assistance from a qualified mechanic.
* After installation, it is necessary to run the car in so that all parts are broken in.