Tools
* Flat head screwdriver
* Wrench or hexagon
Procedure
1. Remove the gear shift knob
* Press the button or release the latch on the top of the handle.
* Pull the handle up to remove it.
2. Remove the selector frame
* There are screws or latches located around the base of the selector.
* Carefully pry and remove the frame.
3. Remove the selector cover
* The selector cover is usually secured with screws or clips.
* Carefully pry and remove the trim.
4. Disconnect the connector
* The electronic connector is located under the selector cover.
* Press the latch and disconnect the connector.
5. Unscrew the automatic transmission selector
* Usually the automatic transmission selector is secured with bolts or nuts.
*Use appropriate tools to unscrew and remove the selector.
6. Disassembling the selector
* You can now disassemble the selector into its individual components.
* This usually includes switches, springs and plastic parts.
* When disassembling, be careful not to lose small parts.
7. Selector assembly
* After troubleshooting or replacing components, reassemble the selector in reverse order.
* Make sure all components are installed correctly.
8. Selector installation
* Reinstall the selector and tighten the bolts or nuts.
* Connect the electronic connector.
* Install the selector cover.
* Install the selector frame.
* Install the gear shift knob.
Adviсe
* Disconnect the battery before starting work.
* Be careful when disconnecting electrical connectors.
* Do not overtighten bolts or nuts.
*If you are not confident in your abilities, consult a mechanic.