Materials:
* Gearbox
* Engine
* Clutch (if required)
*Hydraulic tubes
* Electrical wires
* Fasteners (bolts, nuts)
Tools:
* Wrench set
* Screwdrivers
* Gearbox key
* Jack and stands
* Torque wrench
??:
1. Prepare the vehicle: Place the vehicle on a level surface and apply the parking brake. Raise the front of the car with a jack and support it with stands.
2. Remove the engine and transmission: Disconnect the engine and transmission from the vehicle frame. To do this, you will need to unscrew the mounting bolts, disconnect the hydraulic tubes and electrical wires.
3. Install Clutch (If Required): If your drive uses a clutch, install it to the engine flywheel.
4. Connect the transmission to the engine: Install the transmission to the engine and align them. Make sure the transmission input shaft is aligned with the splines on the flywheel.
5. Install Mounting Bolts: Install and tighten the bolts securing the transmission to the engine. Use a torque wrench to tighten the bolts to the specified torque.
6. Connect the hydraulic pipes: Connect the hydraulic pipes to the transmission and engine. Tighten all fittings.
7. Connect electrical wires: Connect electrical wires to the transmission sensors and solenoids.
8. Install the engine and transmission into the vehicle: Install the engine and transmission onto the vehicle frame and secure them with bolts.
9. Check the operation of the gearbox: Start the engine and shift into gear. Check the operation of the gearbox at various speeds and loads.
Adviсe:
*Refer to the repair manual for your specific vehicle before starting work.
* Use new bolts and nuts.
* Observe the correct order of fastening the bolts.
* Check the transmission fluid level and add if necessary.
* After completing the work, perform a road test to ensure that the transmission is operating properly.