To replace the automatic transmission selector bulb on a Toyota car, you will need the following tools and materials:
* Phillips screwdriver
* New light bulb (part number depends on car model)
*Cloth or gloves
Replacement Guide:
1. Turn off the ignition and put the car on the parking brake.
2. Find the automatic transmission selector panel. It is usually located on the center console.
3. Disconnect the negative terminal of the battery. This is necessary to prevent short circuits.
4. Using a Phillips screwdriver, remove the screws that secure the automatic transmission selector panel to the center console. Typically these are two screws located at the top and bottom of the panel.
5. Carefully pull the automatic transmission selector panel towards you to disconnect it from the center console.
6. Find the automatic transmission selector light. It is usually located at the top of the panel.
7. Gently pull the bulb straight towards you to remove it from the socket.
8. Insert the new light bulb into the socket. Make sure it is fully seated and locked in place.
9. Reinstall the automatic transmission selector panel. Make sure it is properly aligned and secured.
10. Tighten the screws that secure the automatic transmission selector panel to the center console.
11. Connect the negative terminal of the battery.
12. Turn on the ignition and check whether the automatic transmission selector light works.
Adviсe:
* Be careful when disconnecting and connecting the automatic transmission selector panel so as not to damage the wires.
* Use a cloth or gloves when handling the new light bulb to avoid leaving fingerprints on it.
*If you have any difficulty replacing the light bulb, please seek professional help.