Tools:
* Wrench set
* Flat head screwdriver
* New automatic transmission selector
Steps:
1. Disconnecting the battery terminal
* Open the hood and disconnect the negative battery terminal. This will prevent the airbags from inadvertently deploying.
2. Removing the center console
* Remove the two screws at the bottom of the center console.
*Using a flathead screwdriver, pry up and remove the top of the center console.
* Disconnect the electrical connector from the hazard warning button.
* Remove the two screws on the back of the center console.
* Remove the center console.
3. Disconnecting the automatic transmission selector
* Locate the cable running from the automatic transmission selector to the transmission.
* Loosen the cable fastening nut.
* Disconnect the cable from the automatic transmission selector.
* Unscrew the bolts securing the automatic transmission selector to the floor.
4. Removing the automatic transmission selector
* Pull the automatic transmission selector upward slightly to disengage it from the latches.
* Remove the automatic transmission selector.
5. Installation of a new automatic transmission selector
* Insert the new automatic transmission selector into place, aligning the latches.
* Place the cable on the automatic transmission selector lever and tighten the fastening nut.
* Screw the bolts securing the automatic transmission selector to the floor.
6. Installing the center console
* Reinstall the center console.
* Attach two screws to the back of the console.
* Connect the electrical connector to the hazard warning button.
* Reinstall the top of the center console.
* Fasten the two screws at the bottom of the center console.
7. Battery connection
* Connect the negative terminal of the battery.
8. Setting the automatic transmission selector
* Start the car engine.
* Set the automatic transmission selector to the “N” position.
* Make sure that the automatic transmission selector indicator on the instrument panel points to the «N» position.
* If the indicator does not indicate the “N” position, adjust the automatic transmission selector cable.
Helpful Tips:
* Before removing the old automatic transmission selector, make a note of its position in order to correctly install the new one.
* Check the automatic transmission selector cable for wear or damage. Replace the cable if necessary.
*If you are unsure of your skills, consult a qualified mechanic.