Automatic transmission adaptation for Passat B6
Automatic transmission adaptation is necessary to configure the transmission control computer to the individual characteristics of each vehicle. This improves gear changes, fuel economy and overall driving comfort.
Required tools:
*VAG-COM or VCDS adapter
* Computer with VCDS software installed
Adaptation Instructions:
1. Connect the VAG-COM adapter to the vehicle diagnostic port. It is usually located under the steering column.
2. Launch the VCDS software on your computer.
3. Go to the ‘Select Control Module’ section.
4. Select the ‘Transmission’ module.
5. Go to ‘Basic Settings’ section.
6. Select channel ‘060 – Adaptation’.
7. Enter ’00’ in the ‘Value’ field.
8. Click the ‘Read’ button.
9. Move the automatic transmission selector to each position (P, R, N, D, S) for a few seconds.
10. Click the ‘Save’ button.
11. Clear the fault codes by going to the ‘Fault Codes’ section and pressing the ‘Clear All DTCs’ button.
Note:
* If the engine is turned off during adaptation, the procedure must be started again.
*After adaptation, the automatic transmission may take some time to adjust to the new settings.
* It is recommended to adapt the automatic transmission after repairing or replacing transmission components.
Additional tips:
*If you have difficulty adjusting, consult a qualified mechanic.
* Before adaptation, make sure that the transmission fluid level is correct.
*Remember to install updated VCDS software to ensure compatibility with your vehicle.