Required tools and materials:
* Set of ratchet wrenches
* Heads for 13, 15, 16, 18 mm
* 17 mm hex key
* Inner CV Joint Puller
* New inner CV joint
* Grease for CV joints
Procedure:
1. Prepare the car:
*Place the car in park or switch to neutral.
* Keep your vehicle safe by using the parking brake and wheel chocks.
2. Remove the wheel:
* Loosen the wheel bolts using a ratchet wrench and a 19mm socket.
* Raise the car using a jack.
* Remove the wheel.
3. Remove the drive shaft:
* Locate the inner part of the drive shaft connected to the transmission.
* Loosen the six 16mm bolts holding the drive shaft to the transmission using a ratchet and a 16mm socket.
* Pull the drive shaft outward until it comes out of the transmission.
4. Remove the inner CV joint:
* Install the inner CV joint puller onto the CV joint.
* Tighten the puller until the CV joint comes out of the differential.
5. Install a new inner CV joint:
* Apply lubricant to the CV joint.
*Insert the new CV joint into the differential.
* Tighten the CV joint using a puller.
6. Install the drive shaft:
*Insert the drive shaft into the differential.
* Tighten the six 16mm bolts holding the drive shaft to the transmission.
7. Install the wheel:
* Reinstall the wheel onto the hub.
*Tighten the wheel bolts using a ratchet wrench and a 19mm socket.
8. Lower the car:
* Lower the car using a jack.
* Tighten the wheel bolts to the required torque (120 Nm).
9. Check the transmission fluid level:
* Start the engine and let it run for a while.
* Check the transmission fluid level using the dipstick and add fluid if necessary.
Adviсe:
* Be careful not to damage the differential seal when removing or installing the drive shaft.
* Use a new lock nut when installing the inner CV joint.